Introduction

Rover pods are deployed from an existing Regional Controller and consist of a single nodes.

A choice of Dell or HP servers is supported. The choice of which type of servers are deployed is achieved by simply creating different pod specific yaml input files.

In R1 the options include:

Preflight Requirements

Preflight Checks

Preflight Rover Pod Specific Input Data

Example Rover Pod Configuration Input Files

This section contains links to the input files used to build the Rover pods in ATT's and Ericsson's validation labs for the R1 release. Being pods and site specific the enumerated values will differ. Full details of the relevant validation lab setup that should be referenced when looking at these files is contained in the Validation Labs section of this documentation.

Please note, superficially these files may appear very similar but they are all included as examination of the details shows the differences dues to HW differences such as vendor, slot location of NICs as well site specific differences due to VIDs, subnets etc.