...

...

...

...

Hello TSC members,
On the vote this morning, since the resolution voted on is not time sensitive, I would recommend that we hold off until Tuesday (or Thursday), verify that there is quorum and take the vote on the motion as the first thing.  
Looking up the rules did lead to the discovery of a mismatch between our Technical Charter and the Technical Community Document.

Here are important areas (thank you Brett and Andrew):

Technical Charter (3b): Quorum for TSC meetings requires at least fifty percent of all voting members of the TSC to be present. The TSC may continue to meet if quorum is not met, but will be prevented from making any decisions at the meeting. (3c): Except as provided in Section 7.c. and 8.a, decisions by vote at a meeting require a majority vote of those in attendance, provided quorum is met. Decisions made by electronic vote without a meeting require a majority vote of all voting members of the TSC.


Community Document: Introduction "This Technical Community Document is intended to provide additional operational guidelines for the Project, and is subject to the Technical Charter."


Community Document (4.4.1): 
At the transition point and until changed by the TSC there shall be up to 20 seats on the TSC including the chair and co-chair.
Decisions of the TSC should be made by majority vote of TSC Members.
A TSC vote requires a quorum of TSC members to be valid, a quorum consisting of at least 51% of TSC Members present or casting a vote.
Any vote of TSC members that result in a tie shall be considered as not approved.


So given our situation this morning where there were 10 of 20 TSC members present and the vote was 10-0:
According to the Technical Charter, the vote was valid and the motion passed (quorum is 50%, which we had, and a simple majority of the votes cast (6 votes) ).

...