Introduction

...

Note: ELIOT IotGateway Blueprint Deployment has been tested on Cloud VM and is not tested on Bare-Metal Environment. Though, theoretically deployment should work  in bare metal,  provided hardware and software prerequisites are met. Kindly refer R5 ELIOT R6 - Test Documentation of Edge Lightweight IotGateway (ELIOT)IoT Gateway Test Document to get details on the tested deployment.

...

1. Generate public key :

• ssh-keygen -t rsa

2. Setup password-less login - 

• If you get authentication issue you can change the permission

             # Open file:  vi /etc/ssh/sshd_config

                  - PermitRootLogin yes

                  - PasswordAuthentication yes

              # Restart ssh service:

                  - sudo systemctl restart ssh.service

For EdgeGallery AIO mode:

Login from ocd to center and ocd to edge in a single node.

•  sshpass -p <password> ssh-copy-id -p <ssh-port> -o StrictHostKeyChecking=no root@<node_ip>

For EdgeGallery Muno mode:

Login from ocd to center in a controller node

•  sshpass -p <password> ssh-copy-id -p <ssh-port> -o StrictHostKeyChecking=no root@<controller-node_ip>
•  sshpass -p <password> ssh-copy-id -p <ssh-port> -o StrictHostKeyChecking=no root@<edge-node_ip>

Login from ocd to edge in a edge node

•  sshpass -p <password> ssh-copy-id -p <ssh-port> -o StrictHostKeyChecking=no root@<controller-node_ip>
•  sshpass -p <password> ssh-copy-id -p <ssh-port> -o StrictHostKeyChecking=no root@<edge-node_ip>

3.  These command are require in both AIO and MUNO(Controller and Edge Node )  mode.

    cp -p /etc/passwd  /etc/passwd.bkp

    cp -p /etc/group  /etc/group.bkp

    id ubuntu

    groupmod -g 600 ubuntu

    id ubuntu

4. Review and Change Parameters

For EdgeGallery AIO Mode:

...

Once the execution is completed in console will see prompt "ELIOTEdge Environment Installed  , Components Install ELIOT Master and EDGE Nodes Successfully"

...

1. Login to the Master Node and check whether K8S cluster is installed. 
2. Check the below mentioned components and services are running as Pods / Services in Kubernetes cluster
   1. Edge Gallery
   2. grafana
   3. rabbitmq
   4. cadvisor
   5. edgex
   6. Hawkbit
   7. opc-ua
3. Login to Edge Host and verify the worker node setup

 For muno mode

Components and Services running in ELIOT Master NodeController node

Image Added

Components and Services running ELIOT IotGateway/ ELIOT  Edge Node

Image Added

Deploy Application in ELIOT

...

EDGE / IotGateway Node

References

...