Table of Contents
outline true

Introduction

...

To add more Jenkins slave nodes, please follow the Akriano Jenkins guide

To setup private Jenkins, please refer to the README.md under icn/ci/

...

Virtual deployment

Test Framework

All components are tested with end-to-end testing

...

• Nodus provide Provider networks using VLAN networking and Service Function Chaining.
• After the pod is up and running we will be able to attach to the pod and check for multiple interfaces created inside the container. 
• Nodus networking is setup and created

Nodus Validation and test case results

Node Feature Discovery

• Node Feature Discovery for Kubernetes detects hardware features available on each node in a Kubernetes cluster and advertises those features using node labels.
• Create a pod with specific label information in the case the pods are scheduled only on nodes whose major kernel version is 3 and above. Since the NFD master and worker daemonset is already running, the master has all the label information about the nodes which is collected by the worker.
• If the OS version matches, the Pod will be scheduled and up. Otherwise, the Pod will be in a pending state in case there are no nodes with matching labels that are requested by the Pod

...

• Use KUD to setup 3 clusters (sdewan-hub, edge-a, edge-b)
• Run the SDEWAN CRD Controller in each clusters.
• Create SDEWAN CNF instance and dummy pod (using httpbin instead) in edge-a, SDEWAN CNF instance and httpbin pod in edge-b
• Create IPSec CR to configure sdewan-hub as responder to provide virtual IP addresses to any authenticated party requesting for IP addresses through SDEWAN CRD Controller.
• Create IPSec CR to configure edge-a and edge-b IPSec configuration to get the IP addresses through SDEWAN CRD Controller.
• Establish edge-a tunnel to sdewan-hub, edge-b tunnel to sdewan-hub, and hub XFRM policies will automatically route traffic between edge-a and edge-b
• Create SNAT CR to establish SNAT rule in edge-a and DNAT CR to establish DNAT rule in edge-b which will enable TCP connection from edge-a to edge-b's httpbin service.
• Verify curl command is successful from edge-a dummy pod (using httpbin instead) to edge-b's httpbin service. The function of the curl command is to return back the ip address of the requester.

BluVal Testing

Release 6 Blueprint Scanning Status

...