Table of Contents
outline true

Introduction

...

To add more Jenkins slave nodes, please follow the akriano jenkins guide

To setup private jenkins, please refer to the README.md under icn/ci/

...

Virtual deployment

Test Framework

All components are tested with end-to-end testing

...

• Use Kud to setup 3 clusters (sdewan-hub, edge-a, edge-b)
• Run the SDEWAN CRD Controller in each clusters.
• Create SDEWAN CNF instance and dummy pod (using httpbin instead) in edge-a, SDEWAN CNF instance and httpbin pod in edge-b
• Configure Create IPSec CR to configure sdewan-hub as responder to provide virtual IP addresses to any authenticated party requesting for IP addresses through SDEWAN CRD Controller.
• Configure Create IPSec CR to configure edge-a and edge-b IPSec configuration to get the IP addresses through SDEWAN CRD Controller.
• Establish edge-a tunnel to sdewan-hub, edge-b tunnel to sdewan-hub, and hub XFRM policies will automatically route traffic between edge-a and edge-b
• Establish Create SNAT CR to establish SNAT rule in edge-a and DNAT CR to establish DNAT rule in edge-b to which will enable tcp connection from edge-a to edge-b's httpbin service.
• Verify curl command is successful from edge-a dummy pod (using httpbin instead) to edge-b's httpbin service. The function of the curl command is to return back the ip address of the requester.

...