| Table of Contents | ||
|---|---|---|
|
...
Hostname | CPU Model | Memory | BMC Firmware | Storage | 1GbE: NIC#, VLAN, (Connected extreme 480 switch) | 10GbE: NIC# VLAN, Network (Connected with IZ1 switch) | 40GbE: NIC# |
|---|---|---|---|---|---|---|---|
Jump | Intel 2xE5-2699 | 64GB | 1.46.9995 | 3TB (Sata) | IF0: VLAN 110 (DMZ) | IF2: VLAN 112 (Private) | |
node1 | Intel 2xE5-2699 | 64GB | 1.46.9995 | 3TB (Sata) | IF0: VLAN 110 (DMZ) | IF2: VLAN 112 (Private) | |
node2 | Intel 2xE5-2699 | 64GB | 1.46.9995 | 3TB (Sata) | IF0: VLAN 110 (DMZ) | IF2: VLAN 112 (Private) | IF4: SRIOV |
Virtual deployment
Hostname | CPU Model | Memory | Storage | 1GbE: NIC#, VLAN, (Connected extreme 480 switch) | 10GbE: NIC# VLAN, Network (Connected with IZ1 switch) |
|---|---|---|---|---|---|
node1 | Intel 2xE5-2699 | 64GB | 3TB (Sata) | IF0: VLAN 110 (DMZ) | IF2: VLAN 112 (Private) |
Test Framework
All components are tested with end-to-end testing
...
- Use Kud to setup 3 clusters (sdewan-hub, edge-a, edge-b)
- Run the SDEWAN Controller in each clusters.
- Create SDEWAN CNF instance and dummy pod(using httpbin instead) in edge-a, SDEWAN CNF instance and httpbin pod in edge-b
- Configure sdewan-hub as responder to provide virtual IP addresses to any authenticated party requesting for IP addresses.
- Configure edge-a and edge-b IPSec configuration to get the IP addresses.
- Establish edge-a tunnel to sdewan-hub, edge-b tunnel to sdewan-hub, and hub XFRM policies will automatically route traffic between edge-a and edge-b
- Establish SNAT rule in edge-a and DNAT rule in edge-b to enable tcp connection from edge-a to edge-b's httpbin service.
- Verify curl command is successful from edge-a dummy pod(using httpbin instead) to edge-b's httpbin service. The function of the curl command is to return back the ip address of the requester.
...