Introduction
The installation on the preferred hardware
...
is done
...
by booting the system over network. The preferred hardware for a uMEC node is a Raspberry Pi (3B+ or 4B).
...
...
There are instructions on how to
...
In other words, the kernel image, initramfs and root file system are all stored on the server.
...
prepare a MicroMEC cluster for network boot.
In a netboot setup the uMEC nodes load the Linux kernel image and initramfs via TFTP from the netboot server. The root file system of each node is a separate iscsi target on the netboot server. The uMEC nodes login to the iscsi target during boot up.
Upgrading a uMEC node can be done simply by replacing the kernel or changing the root file system on the boot server
...
and rebooting the uMEC node.
The
...
MicroMEC upstream documentation is available online.
License
Apache license
Deployment Architecture
We are currently deploying a
...
3 node system with the installation.
Pre-Installation Requirements
The boot server must have the TFTP/BOOTP server and NFS server installed. For more details please refer to the MicroMEC Netboot document.
Hardware Requirements
Minimum Hardware Requirements
Raspberry Pi
...
3B+
Recommended Hardware Requirements
Raspberry Pi
...
4B
Software Prerequisites
Database Prerequisites
None
Jump Host Requirements
...
In the simplest setup the jump host to the uMEC cluster is the netboot server itself. Requirements of that are defined in the MicroMEC Netboot document.
Network Requirements
The network must allow all messages needed for the network boot to happen. For instance, the client is not able to send VLAN-tagged traffic when it boots. Notice also that dhcp relaying is not reliable, so it is best if the client and server are connected to the same switch or have a direct connection.
Installation High-Level Overview
Bare Metal Deployment Guide
As above.
Virtual Deployment Guide
Booting the image with a virtual machine is not supported. However, a virtual machine image (Vagrant file) is under construction.
...
Validation
The setup must be validated as defined by the Akraino validation feature project plus any additional testing specific to the blue print.
It should be possible to connect to the system with normal kubernetes commands. See k3s documentation.
Uninstall Guide
...
Uninstallation Guide
The uMEC nodes do not store any data. All data is kept on the netboot server, or on the server that hosts the root filesystem (iscsi target). Decommissioning the netboot server means a uMEC cluster can no longer start.