Table of Contents
outline true

Introduction

...

Virtual deployment

Test Framework

All components are tested with end-to-end testing

...

• Use Kud to setup 3 clusters (traffic sdewan-hub, edge1, edge2edge-a, edge-b)
• Create SDEWAN CNF instance and dummy pod in edge1(using httpbin instead) in edge-a, SDEWAN CNF instance and httpbin pod in edge2edge-b
• Configure traffic sdewan-hub as responder to provide virtual IP addresses to any authenticated party requesting for IP addresses.
• Configure edge1 and edge2 edge-a and edge-b IPSec configuration to get the IP addresses.
• Establish edge1 edge-a tunnel to traffic sdewan-hub, edge2 edge-b tunnel to sdewan-hub, and hub policy for XFRM policies will automatically route traffic between edge1 and edge2edge-a and edge-b
• Establish SNAT rule in edge1 edge-a and DNAT rule in edge2 edge-b to enable tcp connection from edge1 to edge2edge-a to edge-b's httpbin service.
• Verify curl command is successful from edge1 edge-a dummy pod to edge2(using httpbin instead) to edge-b's httpbin service. The function of the curl command is to return back the ip address of the requester.

Image Added

Openness

• Install EAA helm charts through ONAP4K8S in the edge location.
• Install Openness simple EAA producer and simple EAA consumer through ONAP4K8S
• Verify EAA consumer can consume the service provided by EAA producer.

...