Table of Contents
outline true

Introduction

...

Virtual deployment

Test Framework

All components are tested with end-to-end testing

...

• Use Kud to setup 3 clusters (traffic hub, edge1, edge2)
• Create SDEWAN CNF instance and dummy pod in edge1, SDEWAN CNF instance and httpbin pod in edge2
• Configure traffic hub as responder to provide IP addresses to any authenticated party requesting for IP addresses.
• Configure edge1 and edge2 IPSec configuration to get the IP addresses.
• Establish edge1 tunnel to traffic hub, edge2 tunnel to hub, and hub policy for traffic between edge1 and edge2
• Establish SNAT rule in edge1 and DNAT rule in edge2 to enable tcp connection from edge1 to edge2's httpbin service
• Verify curl command is successful from edge1 dummy pod to edge2's httpbin service

Openness

• Install EAA helm charts are installed through ONAP4K8S in the edge location.
• Install Openness simple EAA producer and simple EAA consumer are installed through ONAP4K8S to verify the functionality of EAA
• Verify EAA consumer can consume the service provided by EAA producer.

ONAP4K8s:

• ONAP4K8s testing check the health connectivity ONAP Micro service, once it is installed

...