Table of Contents
outline true

Introduction

...

Virtual deployment

Test Framework

All components are tested with end-to-end testing

...

• The SRIOV network device plugin is Kubernetes device plugin for discovering and advertising SRIOV network virtual functions (VFs) in a Kubernetes host. 
• We first determine which hosts are SRIOV capable and install the drivers on them and run the DaemonSet and register Network attachment definition
• On an SRIOV capable hosts, we can get the resources for the node before we run the pod. When we run the test case, there is a request for a VF from the pod, therefore the number of resources for the node is increased.

QAT 

Le Yao (Deactivated)

CMK

Le Yao (Deactivated)

Optane

Tingjie Chen (Deactivated)

SDEWAN

ruoyu.ying

Openness

ChenjieXu (Deactivated)

ONAP4K8s:

• ONAP4K8s testing check the health connectivity ONAP Micro service, once it is installed

...

• Use Kud to setup 3 clusters (traffic hub, edge1, edge2)
• Create SDEWAN CNF instance and dummy pod in edge1, SDEWAN CNF instance and httpbin pod in edge2
• Configure traffic hub as responder to provide IP addresses to any authenticated party requesting for IP addresses.
• Configure edge1 and edge2 IPSec configuration to get the IP addresses.
• Establish edge1 tunnel to traffic hub, edge2 tunnel to hub, and hub policy for traffic between edge1 and edge2
• Establish SNAT rule in edge1 and DNAT rule in edge2 to enable tcp connection from edge1 to edge2's httpbin service
• Verify curl command is successful from edge1 dummy pod to edge2's httpbin service

BluVal Testing

Igor D.C.

CI logs: 

The gerrit comments contains the CI log url. All the CI logs are under this folder ICN : https://jenkins.akraino.org/view/icn/job/icn-master-verify/

...