...

The Target RC has multiple physical and VLAN interfaces. The Build Server uses different interfaces during the different stages of its creation of a RC on the Target Server. A very detailed description of the entire networking setup can be found in the the  Network Architecture section  section of this release documentation <INSERT LINK>.  In In addition the networking configuration with example vlaues as used in the validation labs values similar to that used during validation testing is contained in the Validation Labs section of this release documentation Ericsson Unicycle OVS-DPDK Validation HW, Networking and IP plan. 

The Build Server must have IP connectivity to the Target Server's dedicated BMC port using ports 80 (http) <is 80 actually used?> and  and 443 (https) in order to issue Redfish commands to configure the Target Server's BIOS settings. The Target Server's BMC IP address is denoted as <SRV_OOB_IP> in this guide. The Target Server's BMC must be manually preconfigured with the <SRV_OOB_IP> address.

...

Note: The enumerated IP shown (10.51.34.230) is the an example 'host' address for a RC deployed in a specific validation lab.

Once this has been set and the file saved export the value using 

...

Note: The enumerated IP shown (10.51.34.230) is the an example'host' address for a RC deployed in a specific validation lab.

The final step installs the Regional Controller software:

...

Note: The enumerated IP shown (10.51.34.230) is the an example 'host' address for a RC deployed in a specific validation lab.

The Regional Controller Node installation is now complete.

...

Example RC Configuration Input File on Dell 740XD Servers

This section includes a sample includes an example input file similar to that was used in the Ericsson during Ericsson Validation Lab testing to build a Regional Controller.

...